A pack of 70 isopropyl-alcohol (IPA) saturated surface wipes pre-moistened with 70% IPA solution designed for rapid disinfection of hard surfaces in clinical, aesthetic, and general environments. Each wipe measures 180 mm × 170 mm. The product listing states that it conforms to European standards EN1276 and EN13727 and claims to kill 99.9% of bacteria including MRSA, Listeria, Salmonella and E. coli. The wipes are presented in a flow-wrap pack lined with an aluminium inner and a resealable plastic cap to maintain moisture and prolong shelf-wetness. They are described as thick, extra-strong fabric for deep cleaning and are marketed as a fast-acting formula requiring no water. Pack is made in the UK.
Bnefits
Pre-saturated with 70% isopropyl alcohol for ready-to-use surface disinfection without additional preparation.
Effective against a broad range of bacteria including MRSA, Listeria, Salmonella, E. coli — claimed kill rate 99.9%.
Complies with recognized European disinfection standards EN1276 and EN13727 for bactericidal efficacy.
Convenient flow-wrap packaging with resealable cap to preserve wetness and facilitate repeated use over time.
Wipe size (180 mm × 170 mm) and thick fabric design allow for effective coverage of larger surface areas.
Fast-acting disinfectant that dries quickly and does not require additional water or rinsing.
Indications
Surface disinfection in clinical, aesthetic, medical or salon environments before or after procedures.
Disinfection of hard, non-porous surfaces, instruments and workspaces to reduce risk of cross-contamination.
General hygiene and infection control in outpatient, community, or home care settings.
Suitable for sanitising surfaces in between patient treatments or aesthetic procedures.
Composition
Active ingredient: 70% v/v Isopropyl Alcohol (IPA)
Solvent: remainder water or deionised water (typical for IPA wipes) — derivation from comparable technical data sheets.
Substrate: non-woven wipe fabric (pre-saturated with IPA solution)
No additional biocidal additives (e.g. quaternary ammonium compounds) mentioned — described as PHMB-free and QUAT-free by comparable 70% IPA wipe products.
Formulation
Pre-saturated isopropyl-alcohol wipe (wet wipe) — ready to use without dilution or additional preparation
Single-use wipe (not meant for reuse across multiple surfaces or patients)
Flow-wrap packaging containing multiple wipes (pack of 70) with resealable cap to retain moisture between uses
Packaging
Flow-wrap pack containing 70 wipes, lined with aluminium inner layer to reduce alcohol evaporation and equipped with a resealable plastic cap to maintain wetness.
Each wipe dimension: 180 mm × 170 mm as per product listing.
Outer carton or shipping packaging details not publicly described — only the retail pack specification is given
Usage
Open resealable pack, remove one wipe, and wipe the surface thoroughly using an 'S' shaped motion to ensure even coverage (standard for surface disinfection with alcohol wipes). Similar instructions given across IPA wipe product datasheets.
Use a new wipe for each distinct surface to avoid cross-contamination.
Allow the surface to air dry after wiping; do not rinse with water.
Dispose of used wipes immediately in appropriate waste containers — do not reuse. (General recommendation for single-use disinfectant wipes; no reuse instructions are provided in publicly available listing.)
Ensure adequate ventilation when using alcohol based wipes; avoid sources of ignition due to flammability. (Standard safety advice for IPA products; general formulation hazards recognized in technical data sheets.)
Contraindications
Not for use on skin — designed for surface disinfection only; avoid contact with eyes, mucous membranes, and open wounds. (Aligned with standard IPA wipe safety guidance.)
Not suitable for porous surfaces or materials that may be damaged by alcohol (e.g. some plastics, coatings, varnished wood) — test on small area before full application. (Common recommendation for alcohol surface wipes)
Should not be used near open flames or heat sources; alcohol vapour is flammable. (Based on IPA chemical safety properties as described in technical data sheets)
Adverse Effects
Potential eye or skin irritation if comes into contact with mucous membranes, eyes or broken skin — standard for alcohol-based disinfectants. (As per IPA wipes safety warnings from manufacturer data)
Possible damage or discoloration to alcohol-sensitive surfaces (plastics, painted or varnished surfaces) — test on small area before use.
Risk of fire or inhalation hazard if used near open flame or in poorly ventilated spaces due to alcohol vapour flammability.
Storage Conditions
Store in original resealable packaging to maintain wipe wetness until use.
Keep in a cool, dry, well-ventilated area away from heat sources, sparks, open flame or strong oxidising agents (due to isopropyl alcohol flammability). (Standard IPA storage guidance)
Ensure container is properly sealed when not in use to prevent alcohol evaporation and drying of wipes. (Standard for pre-moistened wipes)
Duration
Not applicable (surface disinfectant wipes; not a medical treatment).
Onset
Immediate to within few minutes \u2014 alcohol kills susceptible microbes rapidly on contact; effectiveness certified under EN 1276 / EN 13727 standards when contact time is respected.
