Logo
Replacement Bulb for Welch Allyn Professional PenLite 76600

Replacement Bulb for Welch Allyn Professional PenLite 76600

Welch Allyn

Diagnostic Equipment & Accessories
  • Supplied as an OEM replacement component for regulated Welch Allyn diagnostic devices; conformity markings and regulatory compliance (e.g., CE/UKCA, electrical safety) apply at the level of the complete penlight system.
  • OEM lamp intended to meet Welch Allyn specifications for performance and safety when used in the 76600 Professional PenLite according to the instructions for use.
Replacement penlight bulb / halogen lamp

Description

The Replacement Bulb for Welch Allyn Professional PenLite 76600 is an OEM halogen lamp designed specifically for the Welch Allyn 76600 Professional PenLite diagnostic penlight. Designated as part number 07600-U, this compact 2.5 V halogen bulb provides bright, white illumination suitable for pupil examinations and general physical assessment. The bulb offers a typical service life of approximately 10 hours of use and is engineered to deliver consistent, reliable light output when installed in compatible Welch Allyn penlights. It is supplied as a single replacement lamp for quick and easy maintenance of the Professional PenLite in clinical settings.

Bnefits

  • Direct OEM replacement lamp for Welch Allyn 76600 Professional PenLite, ensuring proper fit and performance.
  • 2.5 V halogen technology provides bright, white, focused illumination suitable for medical examinations.
  • Designed to offer an approximate 10-hour bulb life under normal operating conditions.
  • Helps maintain consistent, reliable light output without the need to replace the entire penlight.
  • Compact and lightweight bulb that is easy to install by simply replacing the existing lamp.
  • Supports cost-effective maintenance of diagnostic instruments in clinics, hospitals and primary care settings.

Indications

  • Replacement of a failed or dimming bulb in the Welch Allyn 76600 Professional PenLite.
  • Maintenance of illumination quality in Welch Allyn halogen penlights used for pupil evaluation and general physical examination.
  • Use in clinical environments where dependable penlight performance is required for routine diagnostic assessment.

Composition

  • Halogen lamp with tungsten filament in a sealed glass envelope.
  • Halogen gas fill to improve lamp efficiency and life.
  • Metal base and electrical contacts compatible with Welch Allyn 76600 Professional PenLite.
  • Small-form-factor construction designed specifically for Welch Allyn penlights.

Formulation

  • Device type: 2.5 V halogen replacement bulb for diagnostic penlight.
  • Model/part number: 07600-U.
  • Voltage: 2.5 V (nominal).
  • Lamp type: Halogen (HPX-style bright white illumination).
  • Approximate rated life: about 10 hours of use in typical operation.
  • Intended for use exclusively in compatible Welch Allyn Professional PenLite models (e.g., 76600).

Packaging

  • Supplied as a single replacement halogen lamp per unit.
  • Packaged in protective retail/clinical packaging to prevent damage during storage and transport.
  • Labelling typically includes Welch Allyn branding, part number 07600-U and basic identification as a replacement lamp for the Professional PenLite.

Usage

  • Ensure the Welch Allyn Professional PenLite is switched off and remove any batteries before replacing the bulb.
  • Unscrew or open the lamp end of the penlight according to the manufacturer’s instructions for the 76600 Professional PenLite.
  • Carefully remove the existing bulb by pulling it straight out or unscrewing it, depending on the lamp holder design.
  • Insert the new 07600-U halogen bulb into the socket, ensuring proper alignment and secure seating of the contacts.
  • Reassemble the penlight and reinstall the batteries, observing correct polarity.
  • Switch on the penlight to check that the new bulb illuminates correctly with a bright, even beam.
  • Avoid touching the glass envelope of the halogen bulb directly with bare fingers; if necessary, handle using clean gloves or a tissue to minimise oils on the glass, which can shorten bulb life.
  • If the lamp fails to illuminate after installation, verify battery condition, polarity and that the bulb is properly seated. If problems persist, consult the device manual or a service technician.

Contraindications

  • Do not use this bulb in devices other than compatible Welch Allyn penlights designed for the 07600-U lamp type.
  • Not suitable for use in explosive or flammable atmospheres unless the complete penlight system is certified for such environments.
  • Do not operate the lamp at voltages or with battery configurations other than those specified for the Welch Allyn Professional PenLite.
  • Do not use a damaged bulb (e.g., cracked glass, bent or corroded contacts).

Adverse Effects

  • Under normal use, no direct patient adverse effects are expected, as the bulb is enclosed within the penlight housing.
  • If the penlight or bulb overheats due to misuse or electrical fault, there is a potential risk of burns from hot surfaces.
  • Broken glass from a damaged bulb can cause cuts or puncture injuries if handled improperly.
  • Very bright light directed into the eyes at close range for prolonged periods may cause temporary discomfort or glare; standard clinical practice avoids unnecessary prolonged exposure.

Storage Conditions

  • Store the unused bulb in its original protective packaging until use.
  • Keep in a cool, dry place away from moisture, dust and direct sunlight.
  • Avoid mechanical shock, crushing or dropping, which may damage the filament or glass envelope.
  • Keep out of reach of children and untrained personnel to prevent accidental breakage or misuse.

Duration

Onset

Browse more Diagnostic Equipment & Accessories

Top Treatments

Top Cities in the UK